BTC: 1CxnFVKpFadhpnkj4MtuadzEXULnG7hPrW
Eth: 8e61bf5a2e46d15774172781cf100ed0962cbb63

Wednesday, March 16, 2016

Fix it Bible: PCIe 1x to 16x Risers for GPU Mining



Powered and pin shorted
Came across problems getting my 1x to 16x PCIe risers to work on my GIGABYTE GA-F2A88X-UP4 motherboard. Several forum posts from litecoin forums have descriptions on how to solve these types of issues but they aren't all in the same place. Here's a conglomeration of all the potential issues you could be facing if these risers don't work immediately when you plus them in.



BIOS  Settings - The fickle mistress, there are lots of settings in here that can trip you up. Some key things that need to be set here, make sure your PCIe cards are set to run as Gen 2.0 not auto. Gen 2.0 is the most likely config that your extenders will work with. On some motherboards there are a limited number of systems that can be run simultaneously and some periferals will take priority over your PCIe 1x slots. To fix this, you need to disable these extra periferals. As a last resort, disable the USB 3.0 driver and the SATA driver. I managed to get my system working with both of these on however.

Powered
Unpowerd
Unpowered Riser - Whatever type of riser you buy, make sure it has a a 4 prong power port. The PCIe bus can demand up to 75w of power and an unpowered riser will cause you trouble. Make sure that a ground wire is also included. It's good to get one that has a capacitor between the ground and the power to smooth out any power flucuations.


Shorting Pins - Sometimes people recommend shorting some pins on the PCIe board. This is not typically required anymore because the pin shorts have been built into the card. This is the case with the USB3 riser in the top picture. If you look at the trace of the metal, you can follow it and it clearly shows that the two required pins have been shorted.


Image result for power supply EVGAPower Supply - Video cards draw a lot of power and if you don't have a large enough power supply, they may not power up properly. The typical R9 280 & R9 380 draw around ~200W, your R9 290 and R9 390 will probably draw around ~300W. Make sure you're power supply can handle the demand of all your cards turned on or you may undervolt stuff and cause it to malfunction. If you want to be precise in your power calculations, pickup a Kill a Watt EZ meter and sample your power usage over an hour. Make sure to add +20% margin for spike load. So if your meter says you are using 100W on average, make sure your power supply is rated for 120W.


Default Graphics Output - /u/arthropal pointed out that "motherboards will usually initialize whatever is in the top slot as the active console card, so if they have an extender on a top slot that's 1x, and they are trying to see output on the card in the top full sized slot, which is below that 1x slot, they will get black screen and seemingly no boot." To overcome this issue, make sure to fix the default graphics card selected in your BIOS settings.
 
Integrated Graphics Cards - On some motherboards you have integrated graphics cards. Depending on your OS, these graphics cards will fight for control of the video output with your plugged in PCIe GPU. I've had this trouble on Ubuntu and I had to specifically force both BIOS and Ubuntu to use the integrated graphics card, leaving my GPUs for mining only. Forcing integrated graphics in BIOS only is not enough.

OS Issues - There are some OS specific limitations to getting multiple GPUs to work but usually it's only after you've plugged in 6 or more GPUs. If you only plug in your powered riser and remove all other other cards and it doesn't work, it's probably not an OS issue.